Created with Sketch. Created with Sketch.

Shop by Category

Pro Tech

  • 5-Point Racing Harness 1/16

    5-Point Racing Harness 1/16

    5-Point Racing Harness with metal cast buckles and ready to use harness material.Not your flat photo-etched hardware. This is cast for 3D texture and detail. Pro Tech's own design makes it easy to...

    $4.75
    Add to Cart
  • Aluminum Gas Cap 1/16

    Excellent detail for your race car fuel cell, hot rod Moon tank and other tanks like an oil tank on a Funny Car, Pro Mod or Dragster.Can also be used for a radiator cap, engine oil breather cap or...

    $3.25
    Add to Cart
  • Aluminum Ignition Coil 1/25

    Machined aluminum ignition coil with rubber boot.Use with your color choice of Pro Tech Spark Plug Cable. Coil shown with Pro Tech's distributor kit, flex fan, spark plug wires, spark plug boots,...

    $3.25
    Add to Cart
  • Barrel Valve 1/16

    A barrel valve is located on the left side of a supercharged engine injector hat. The fuel input is via a braided line from the fuel pump and 2 outlet braided lines go to 2 fuel junction blocks (see...

    $2.75
    Add to Cart
  • Braided Line  .018 Dia

    Braided Line .018 Dia

    This is the smallest braided line by Pro Tech.Depending on your scale, typical uses are brake lines, small fuel lines like Nitrous, oil lines, gauge and other control lines, etc.The scale size is...

    $4.75
    Add to Cart
  • Braided Line .025 Dia

    Depending on your scale, typical uses are fuel, nitrous, oil lines, small heater and coolant hoses and other small transfer lines.The scale size is determined by its outside diameter (OD) compared to...

    $4.75
    Add to Cart