Competition Resins 1/16 Scale

Blower 14-71, 1/16

A nice 14-71 blower with an end plate and front plate including a cogged pulley   Resin, 1/16 scale, by Competition Resins.

Oil Pan, HEMI 1/16

A flat-style oil pan for a HEMI or BBC   Resin, 1/16 scale.

Round 3-Hole Injector Hat 1/16

Round 3-hole injector hat with molded-in fuel junction block.   Resin, 1/16 scale, by Competition Resins.

Sullivan Flat-Welded Fuel Tank 1/16

A Sullivan flat-welded fuel tank. Contains 1 resin tank, 1/16 scale

ET III Style Rear Wheels 1/16

ET III 'Bear Claw' style 2-piece rear drag racing wheels. Fits Revell tires.                                Photos of real wheels          ...

Blower Pulleys 1/16

Crank, Blower and Idler pulleys for that blown engine.   3 pieces, resin, 1/16 scale.

12-Spoke Front Wheels 1/16

12-Spoke front drag racing wheels. 2 resin pieces, resin, 1/16 scale.

Donovan HEMI Engine with Clutch Can and Lenco 1/16

A complete blown 417 Donovan engine with clucth can and Lenco transmission, with reverse. Complete with pulleys, breathers, blower starter bracket, blower, injector hat and more. The block has pins to correctly align the heads. The resin casting is...

70's Ribbed Injector Hat 1/16

1970's style 3-port ribbed-top injector hat.   See also, photo eteched butterfly set to fit this injector.   Resin, 1/16 scale.

Dragster or Fuel Altered Front Tires 1/16

Skinny front tires for wire or spoked wheels, as found on dragsters and altered. Measurements: 1" OD 0.7" ID These tires fit the Comp Resins 12-spoke wheels found here. Contains 1 pair rubber-like tires.

Cragar Super Trick 8-hole Rear Wheels 1/16

Cragar Super Trick, 8-hole rear drag racing wheels. Fits Revell tires...

5-Slot Rear Wheels 1/16

A 2-piece, 5-slot rear racing wheel. Fits Revell tires. Contains 4 resin pieces/2 wheels.

Shotgun 2-Hole Injector Hat 1/16

Contains 1 'Shotgun' type 2-hole resin injector hat. See also, photo etched butterfly discs made for this injector.   Resin, 1/16 scale.

M&H Racemaster Drag Slicks 1/16

M&H Racemaster Drag Slicks. Raised 'M&H Racemaster' on sidewall. These are a hard resin and do not have a lot of room for play with wheel sizes. Tire Measurements: Width 1.00",  25.4mmDiameter. 2.00", 50.8mmWheel opening 1...

Late Model Enderle Injector Hat 1/16

An Enderle 3-port injector hat.   See also, photo eteched butterfly set to fit this injector.   Resin, 1/16 scale.

671 GMC Blower 1/16

A 671 blower for early dragsters or for a street machine.Blower pulley is attached to the front plate.The detail is quite good and the bolts are sharp. Check out this photo for an idea of which blower you need. Contains 2 resin pieces.