Fuel Management

  • Tee Fitting, Small

    This is an inline fitting for braided lines, hard lines or hoses.Typical uses are splits for carburetor fuel lines and brake lines.Use Pro Tech .025 Braided Line and matching Fittings. Each package contains one T fitting, by Pro Tech. Metal Cast

    $2.00
    Add to Cart
  • Tee Fitting, Large

    This is a large inline fitting for braided lines, hard lines or hoses.  Anywhere you have a split.Typical uses are dual feed carburetors, tunnel ram, oil lines and brake lines.Use Pro Tech .035 Braided Line and matching Fittings. Each package...

    $2.00
    Add to Cart
  • Blown Engine Fuel Plumbing Schematics

    All the information you need to plumb the fuel lines on a modern blown engine. A few lines can be changed to represent older blown engines.Covers all the fuel lines from the fuel cell to the injectors, listed in 4 different scales: 1/25, 1/16, 1/12,...

    $2.00
    Add to Cart
  • Soft Line - Hose .020, .5mm OD

    This is my smallest soft, solid rubber line . It's the perfect thing for those small fuel or nitrous lines at the engine.  It can bend at a sharp angle without kinking.See Hex Fittings sized at .020 for this soft line. This soft line equals the...

    $2.25
    Add to Cart
  • Fuel or Brake Hard Line .020, .52mm Dia

    This solid aluminum line is soft to bend and will not kink, even at tight angles. It straightens out easily and will conform to any shape you want.This aluminum 'hard' line equals the following equivalent 1:1 size at each scale.1/25 scale = 1/2"1/16...

    $2.25
    Add to Cart
  • Brake, Nitrous or Fuel Line .010, .25mm Dia

    This solid aluminum line is the smallest available.  It's soft to bend and will not kink, even at tight angles. It straightens out easily and will conform to any shape you want.This aluminum 'hard' line equals the following equivalent 1:1 size at...

    $2.25
    Add to Cart
  • Blown Engine Fuel Injection Block 1/16

    Fuel Injection Block for supercharged engines. This is the fuel block that is located behind the injector hat and behind the blower which feeds the manifold. Use Pro Tech’s .035 Braided Line along with the corresponding fittings for the fuel feed line to...

    $2.75
    Add to Cart
  • Throttle Linkage 1/16

    Throttle Linkage 1/16

    Whether it's a blown engine, injected or carbureted, these photoetched pieces will detail your throttle linkage. For the metal linkage that fit into the holes, use the .014 and .020 aluminum lines.  These are stiff enough to hold...

    $5.75
    Add to Cart
  • Soft Line-Hose-Release Cable .014, .35mm OD

    This is my smallest soft line.  It's nylon coated stainless steel which can be tightly bent and it can hold its shape if bent tight enough. I've used it for a parachute-release cable fromt the cockpit parachute release lever to the parachute and it...

    $2.50
    More Coming