Created with Sketch. Created with Sketch.

Shop by Category

Fuel Management

  • Fuel or Brake Hard Line .020, .52mm Dia

    This solid aluminum line is soft to bend and will not kink, even at tight angles. It straightens out easily and will conform to any shape you want.This aluminum 'hard' line equals the following equivalent 1:1 size at each scale.1/25 scale = 1/2"1/16...

    $2.25
    Add to Cart
  • Tee Fitting, Large

    This is a large inline fitting for braided lines, hard lines or hoses.  Anywhere you have a split.Typical uses are dual feed carburetors, tunnel ram, oil lines and brake lines.Use Pro Tech .035 Braided Line and matching Fittings. Each package...

    $2.00
    Add to Cart
  • Barry Grant DEMON 4bbl Carburetor 1/16

    Barry Grant DEMON 4bbl Carburetor 1/16

    Detailed Barry Grant 4bbl CarburetorWith single or dual carbs, you'll need Pro Tech's 1/16 scale Fuel Junction Block.Also see the Braided Lines, Hard Lines, Soft Lines and Fittings along with the T fitting to split the fuel line to each carb. One...

    $2.75
    Add to Cart
  • Holley Dominator 4bbl Carburetor 1/16

    Holley Dominator 4bbl Carburetor 1/16

    Detailed Holly Dominator 4bbl CarburetorWith single or dual carbs, you'll need Pro Tech's Fuel Junction Block.Also see the Braided Lines, Hard Lines, Soft Lines and Fittings along with the T fitting to split the fuel line to each carb. One per...

    $2.75
    Add to Cart
  • Barrel Valve 1/16

    A barrel valve is located on the left side of a supercharged engine injector hat. The fuel input is via a braided line from the fuel pump and 2 outlet braided lines go to 2 fuel junction blocks (see ENGINE DETAILING).Designed for Pro Tech .035 Braided...

    $2.75
    Add to Cart
  • Blown Engine Fuel Injection Block 1/16

    Fuel Injection Block for supercharged engines. This is the fuel block that is located behind the injector hat and behind the blower which feeds the manifold. Use Pro Tech’s .035 Braided Line along with the corresponding fittings for the fuel feed line to...

    $2.75
    Add to Cart
  • Carburetor Fuel Junction Block 1/16

    For your single or dual carburetor setups.  Made with molded-on fittings.Use .035 Braided Lines and Fittings and large T fitting. Each package contains 1 Fuel Junction Block, by Pro Tech. Resin cast

    $2.75
    Add to Cart
  • Throttle Linkage 1/16

    Throttle Linkage 1/16

    Whether it's a blown engine, injected or carbureted, these photoetched pieces will detail your throttle linkage. For the metal linkage that fit into the holes, use the .014 and .020 aluminum lines.  These are stiff enough to hold...

    $5.75
    Add to Cart
  • Rod Ends/Link/Heim Kit 1/16

    Cast metal parts for your suspension or throttle linkage detail.  Can be used for heim joints/rod ends in suspension areas like a 4-link rear end, panard bar or front radius rods. Use in combination with Pro Tech's Throttle Linkage kit for a...

    $2.75
    Add to Cart
  • Blown Engine Fuel Plumbing Schematics

    NEW AND UPDATED All the information you need to plumb the fuel lines on an early or modern blown engine. A few lines can be changed to represent older blown engines.Covers all the fuel lines from the fuel cell to the injectors, listed in 4...

    $2.00
    Add to Cart