Created with Sketch. Created with Sketch.

Shop by Category

Fuel Management

  • Small Air Cleaner 2-Set 1/25

    Small Air Cleaner 2-Set 1/25

    A pair of nicely detailed oval air cleaners. Approximately 3/8" long. Includes: Top with ball-grooves Bottom, solid Louvered sides Mesh filter material  Assembly is required.   Photo etched sheet, by Highlight Model Studio, 1/25...

    $5.45
    Add to Cart
  • Molded Blower Belt with Pulleys 1/25

    A more detailed blower belt set than found in kits. The belt shows cogs on the inside and bolt heads are found on the pulleys. Also has the blower pulley, crank pulley and idler pulley molded in..   Blower pulley to Crank pulley center-to-center...

    $1.95
    Add to Cart
  • Einstein Blower Hat and Base 1/25

    Einstein Blower Hat and Base 1/25

    Here's a different blower hat.  It's similar to the Janis style. Includes a plate with an injector distribution block. Overall height is 1.00". Three pieces in resin   By Competition Resins, 1/25 scale.    

    $6.50
    Add to Cart
  • Dual Quad Tunnel Ram Manifold 1/25

    Set a pair of Dominator or Demon carbs on top of this manifold. Make sure you have room under your hood or cut a hole in the hood to allow for the height. Overall height is .43" (7/16"). Molded in one piece.   One resin piece by Competition...

    $5.00
    Add to Cart
  • S.C.O.T Blower 1/25

    Here's a special blower for that Flathead engine. S.Co.T. is an abbreviation for 'Supercharger Company of Turin' (Torino), Italy. It was one of the most popular "roots" style blowers in the 1950's and popular today on Street Rods and Rat Rods...

    $5.00
    Add to Cart
  • Holley Dominator Carburetor (Pair) 1/25

    Holley Dominator Carburetor (Pair) 1/25

    A pair of nicely detailed Holly Dominator 4-bbl Carburetors. With single or dual carbs, you'll need a Fuel Junction Block (see ENGINE DETAILING). Also see the Braided Lines, Hard Lines, Soft Lines and Fittings along with the SMALL or LARGE 'T' fitting...

    $5.00
    Add to Cart
  • Soft Line - Hose .008", .20mm OD

    This is the smallest black soft line I have. This is a black nylon-coated stainless steel multi-strand wire. It is slightly springy and can be bent at sharp anglesThe OD dimension is .008" or .20mm.  This soft line equals the following equivalent...

    $2.00
    Add to Cart
  • Soft Line - Hose .010", .25mm OD

    This is a black nylon-coated stainless steel multi-strand wire. It is slightly springy and can be bent at sharp anglesThe OD dimension is .010" or .25mm.  This soft line equals the following equivalent 1:1 size at each scale.1/25 scale = 1/4"1/16...

    $2.00
    Add to Cart
  • Soft Line - Hose .015", .38mm OD

    This is a black nylon-coated stainless steel multi-strand wire. It is slightly springy and can be bent at sharp anglesThe OD dimension is .015" or .38mm.  This soft line equals the following equivalent 1:1 size at each scale.1/25 scale = 3/8"1/16...

    $2.00
    Add to Cart