1/25 - 1/24 Scale

Salt Lake Style Moon Wheel Covers 15" 1/25

A set of four spun aluminum large Moon hubcaps. These are found on early custom cars and often found on Salt Lake racers. This is made of solid aluminum and has a flat back. Measures 5/8" diameter or a scale 15". Four aluminum pieces by Parts by Parks,...

Weld Pro Star 4-Wheel Set 1/25

A set of four Weld Pro Star Racing Wheels - front and rear. Photo shows centers as one solid piece but the '5-spokes' cut out. Includes deep rear wheels and front wheels showing lug nuts.   Contains 2 pairs resin wheels, 1/25 scale.

Gasser Slotted Front Wheels 1/25

A pair of 5-slot front wheels. Popular on gassers, super stock or pro stock cars. These are similar to the Fenton Front Wheels, but these have slightly smaller slots    One pair of resin wheels by Competition Resins, 1/25 scale.

Pro Stock/Pro Mod Wing 1/25

This wing has a small arch as viewed from the toop. Has teardrop end plates. Measurements: Overall length: 2.15" Width at end plates: .52" Contains 1 resin piece, 1/25 scale

Micro Sol, Setting Solution

Microscale's Micro-Sol is a decal "setting" solution for the most difficult irregular surfaces to be found on models. It allows the decal to drape down onto the surface of the model, conforming perfectly to surface irregularities without distortion...

Micro Set, Setting Solution

Microscale's Micro-Set is a decal "setting" solution that softens decals and improves adhesion plus lets the decal conform to the model's surface. To apply Micro Set: Use a soft flat artist's brush and apply Micro Set where you are going to apply the...

Wide Rear Steel Wheel Pair 1/25

A pair of deep rear wheels. These are stock looking steel wheels with lug nuts, except they're wide to hold big rubber. Great for street racers, early Super Stock or Pro Stock and Rat Rods. Width/Depth = .33" (11/32")   Contains 2 resin wheels by...

Dual Quad Tunnel Ram Manifold 1/25

Set a pair of Dominator or Demon carbs on top of this manifold. Make sure you have room under your hood or cut a hole in the hood to allow for the height. Overall height is .43" (7/16"). Here's a photo of a real dual quad setup byRich Vitiritti. ...

Radio Faces 1/24-1/25

A set of photo-etched radio and other electronic device faces. A black wash will highlight the details and subdue the lower areas. Photo etched sheet. By Detail Master, 1/25 scale.  

Dragster Wire Wheels 18" 1/24

Finally, a wire wheel with real spokes that looks realistic. Fully assembled and includes 3D-printed tires painted Tamiya TS-82 "Rubber Black". A single Timing Disc Light Shield option is available that is a separate stainless steel piece which can be...

Billet Shifter/Dash Knobs - Piston Style 1/24-1/25

A shifter knob, dash knobs or maybe a turn signal knob in the shape of a piston. Includes two knobs. This would be perfect with Detail Master's steering column. Aluminum parts By Detail Master, 1/24-1/25 scales.

Hurst Shifter Kit 1/24-1/25

You can't build an accurate muscle car, '60s gasser, or drag racer without this shifter. This kit replicates the real thing with 'HURST' shown on the arm sides. Includes 9 different arms, 6 boot rings and 8 round knobs.     Photo etched parts...