Product Description
A 3D-printed MSD Pro Mag 44 with a decal.
It consists of three pieces - Body, Cap and Cover, to make it easy to run the wires through. An MSD decal is included but not shown in the photos.
The ignition wires pass through the openings of the cap. Cut four spark plug wires long enough for each one to feed two spark plugs. There's less gluing in the cap this way.
Boots could be shortened to just stick out between the cap 'posts'.
A drive is available to add another Pro Mag. The holes in the Pro Mag body and the Drive accept a 1.5mm shaft.
Here's what a dual mag setup looks like. You might also want to checkout my Front Mag Drive Timing Cover (shown in photo below)
Check out the FREE downloadable PDF file for Pro Mag ignition wiring.
Don't forget the Spark Plug Wire and wire looms for even more detail.
By Ted's Modeling, 1/25 scale.
