1/25 - 1/24 Scale

BBC Valve Covers with Bowtie Logo 1/25

A pair BBC valve covers with the Chevy Bowtie emblem on the surface. NOTE: I highlighted the emblem on one valve cover to show the image better. 

Clutch Can HEMI 1/25

 Here is an item every race car needs and is required in almost all NHRA classes. This clutch will contain a clutch/flywheel explosion.

Stock Width 9" Rear End & Brake Kit 1/25

Here is a complete 9" Ford OEM-style rear end with brakes. This version is the stock width (2-1/4") and there is a narrowed width Ford 9"

Street Rod Gauges Set #1, Black 1/25

Enough photoetched trims and BLACK gauge faces for four cars. This will add detail to your interior.These gauges are popular in '30 - '34 Street Rods and Roadsters with flat dash boards. They are...

Timing Covers, Pump, T'Stat, Balancer, 1/25

This combination will detail the front of your SBC or BBC engine. CONTAINS: 2 Timing Covers, different size to fit different

Blower Restraint Plate, 1/25

This restraint plate sits under the blower and restraint straps would fasten to the slots and go over the blower to hold it down in the event it would blow up. It is universal to all blowers.

Dragster Wire Wheels 20" without Light Shield 1/25

Real wire wheels with real spokes for newer/nostalgia dragsters. Fully assembled and includes 3D-printed tires painted Tamiya TS-82 "Rubber Black".

Holley Dominator Carb & PE Details, Pair 1/25

Holley Dominator Ultra Detail Carb Kit with Photo Etch Air Horn and Linkage.  These carbs were drawn in CAD and capture as many features as possible of Holley's decades-famous Dominator race carb.

Gasser & New Graphics Decal Sheet #2, 1/25

1/25 scale mini decal sheet with Gasser graphics plus a few sponsors for newer cars or rat rods. Includes (2 of each)  M&

BBC Offset Motor Plate 1/25

A more accurate motor plate than found in a kit. It is offset for those cars with an off-center driveline.While this motor plate is copied after the one used in the Revell Pro-Sportsman kits, it can...

Rear Tube Frame/Clip .800" Wide 1/25

A round-tube rear frame clip ready to install.  It's 3D printed in FUD material. Dimensions are:Frame width = .800"

Stock Width 9" Rear End 1/25

Here is a nicely detailed 9" Ford OEM-style rear. This version is the stock width (2-1/4") and there is a narrowed width Ford 9"