Shop by Manufacturer

Street Rod Gauges Set #1, Black 1/25

Enough photoetched trims and BLACK gauge faces for four cars. This will add detail to your interior.These gauges are popular in '30 - '34 Street Rods and Roadsters with flat dash boards. They are typically mounted in the center of the dash or over...

Valve Cover T-Bolts, Photoetched 1/25

Add realism to your engine bay with these Valve Cover T-Bolts. They're long valve cover bolts that have a T shape at the top.There are enough valve cover bolts here for a few cars. One set photoetched, by Pro Tech.

Clutch Can HEMI 1/25

 Here is an item every race car needs and is required in almost all NHRA classes. This clutch will contain a clutch/flywheel explosion. This is a replica of a real world Trick Titanium clutch can and matches the bellhousing pattern on HEMI blocks...

Rust Streaks Weathering by AK Interactive, FREE

This is a FREE downloadable PDF file for weathering rust effects using AK Interactive's Rust Streaks Weathering Set. You don't have to buy anything to download this file, but you still have to go through the checkout procedure. Just add this to...

Dragster Wire Wheels 20" with Light Shield 1/25

Real wire wheels with real spokes and one wheel has a 'light shield' timing disc on one side for newer/nostalgia dragsters. The light shield provides a larger area to trigger the staging lights and the timing lights at the end of the strip. Fully...

Gasser & New Graphics Decal Sheet #2, 1/25

1/25 scale mini decal sheet with Gasser graphics plus a few sponsors for newer cars or rat rods. Includes (2 of each)  M&H Racemaster "Gas Chamber" "The STRIP Teaser" Moon Eyes New York National Speedway logo "Rapid Ronnie" A/Gas,...

Bomber Seats (2) Set #2, 1/25

A pair of bomber seats for that hot rod, rat rod or other project. Directions are not included, but here is a link to a PDF file showing assembly.   Photo etched and assembly is required.   Two seats, by Highlight Model Studio, 1/25 scale.

BBC Offset Motor Plate 1/25

A more accurate motor plate than found in a kit. It is offset for those cars with an off-center driveline.While this motor plate is copied after the one used in the Revell Pro-Sportsman kits, it can be used in any build with possible modification.It is...

Rear Tube Frame/Clip .800" Wide 1/25

A round-tube rear frame clip ready to install.  It's 3D printed in FUD material. Dimensions are:Frame width = .800"Frame tube diameter = .080"Cross member diameter = .080"Overall length = 2.55" Two other frame clips widths are available in .700"...

Wheelie Bar Housing Kit 1/16

Here is a Wheelie bar wheel housing kit designed for today's PM, FC, ADRL, SS, and others. Includes PE wheel housing and PE and resin wheels which must be assembled. Fabrication required. Does not include mounting hardware.   Assembly and...

Aluminum Hard Line .078", 2mm Dia

This aluminum hard line equals the following equivalent 1:1 size at each scale.1/25 scale = 2"1/16 scale = 1 1/4"1/12 scale = 1"1/8 scale  = 5/8"Depending on your scale, typical uses are larger coolant (radiator) and fuel lines, like from the...

Small Multi-Use Springs, Throttle/Hood/Brake (pair)

Two small springs for throttle linkage or to hold those semi tractor air hoses.Depending on your scale, these could be used for brake pad springs or hood-hinge springs.Spring length is .25"Contains two (2) steel springs, compression type, by Model Car...