Blower Belt, 1/16

This 1/16th scale ribbed blower belt fits Revell Hemi engines, as well as other engines, but the pulley cogs may be different.  It is cast out of urethane rubber and stretches enough to fit nicely over the kit pulley setup.  It can fit...

Blower Restraint Plate, 1/16

This restraint plate sits under the blower and restraint straps would fasten to the slots and go over the blower to hold it down in the event it would blow up. It is universal to all blowers.   This photo etched piece is etched out of .016"...

Throttle Linkage Set, 1/25

A throttle linkage set with pins added to the ends of the linkage components. This will provide a more stable attachment point for linkage rods, etc. Depending on your attachment, the pin may have to be bent 90 degrees.   Photo etched...

Dana Rear End, Standard Width, Bare 1/25

Here is a Dana rear end in a standard width, molded in white resin. Overall length between axle tube ends is 2.25" The width can be shortened to suit your build by cutting the axle tubes. A Dana rear with the brake kit is available here.   See...

Stock Width 9" Rear End 1/25

Here is a nicely detailed 9" Ford OEM-style rear. This version is the stock width (2-1/4") and there is a narrowed width Ford 9" found here. This rear is also available with an included brake set and in either in black or white. The width can be...

Holley Dominator Multi-Media, Pair 1/16

Holley Dominator multi-piece Carb Kit with Photo Etch Air Horn and Linkage Carbs separate into separate main body, metering blocks and float bowls for extra detailing! The carb bodies are based off 3D-printed masters. They are supplemented with...

Vintage Graphics Decals, 1/25

Lots of early Pro Stock & Super Stock related graphics. Includes: All major car manufacturers Hurst Shifter Hooker Headers Champion Wynn's Super Stock racing classes and more - see the product photo  Measures 7" x 4.75"   One...

Gasser Graphics Decals #2, 1/25

Lots of Gasser and Rat Rod related graphics. Includes: Hurst Shifter Mooneyes (2 sizes) American Flag Letters to make A/G, B/G, etc for gasser classes and more - see the product photo  Measures 7" x 4.75"   One decal sheet, by...

Round Air Cleaner, Spun Aluminum, 1/25

A realistic round spun aluminum Air Cleaner. It has a screen air filter between the top and bottom halves. Dimensions: Diameter - .45" Overall Height - .19"   No assembly required.   By Parts by Parks, 1/25 scale.

3-Pulley Set, 1-Groove 1/25

A set of three spun aluminum V-groove pulleys. Consists of three single groove pulleys. Includes belt material. The package list this pulley set for SBC engines in AMT's '33 Ford (kit #6714) and AMT's '34 Ford (kit #6686) but these can be used on any...

Engine Detailing Kit Plus #2, 1/25

An engine wiring and plumbing kit Consists of: Radiator hose, black Heater hose, red Black detailing wire (battery, ignition, etc) Red detailing wire (battery, ignition, etc) Two sizes of aluminum line  By Parts by Parks, 1/25 scale.

1967 Camaro Z28, 1/25

The initial release of the Chevrolet Camaro was 1967. The Z28 was their high performance version. This AMT Z28 is new for 2022 with new tooling.   Assembly Required. By AMT, 1/25 scale