Engine Related

572 Valve Cover Decal Sheet - Chrome 1/25

Five pairs of "572 CHEVROLET" valve cover decals with a shiny 'chrome' look. Decal sheet measures 1" x 1.75" If you compare the two decal phot

Round Air Cleaner, Spun Aluminum, 1/25

A realistic round spun aluminum Air Cleaner. It has a screen air filter between the top and bottom halves. Dimensions:

Blower Belt, 1/24-1/25

This ribbed blower belt really adds detail and realism over a molded kit belt/pulley item. It is cast out of urethane rubber and stretches enough to fit nicely over the a pulley setup. 

Dodge 'Red Ram' HEMI Valve Covers 1/25

A pair of Dodge HEMI valve covers with lettering. DODGE and Red Ram are printed in raised lettering.

MSD Pro Mag 44 #1, 1/25

A 3D-printed MSD Pro Mag 44 with a decal. It consists of three pieces - Body, Cap and Cover, to make it easy to run the wires through. An MSD decal is included but not shown in the photos.

Blower Accessory Set 1/25

This photo etched set includes: Blower hold-down plate Blower restraint strap buckles

Spark Plug Boots-Straight, Red-Gray, 3D, 1/25

A package of 16 straight 3D-printed spark plug boots in red or gray. 8 for the spark plugs and 8 for the distributor.   

Lenco Transmission 3-Speed/Reverse, Manual Shift 1/25

This is a complete Lenco transmission configured for 3-speeds with reverse. It is a one-piece unit including 3D-printed shifter levers (the 2 levers are really small and easy to loose).

Line Retainers/Clamps - Multiple Scales

Retainer Clamps for fuel, brake lines, wire etc in three different sizes. Holds braided lines, soft lines, hard lines or wires in place. Small - .018" ID Medium - .025" ID Large - .035"...

Pre-Wired 6-cyl Distributor, Black Cap, 1/25

An authentic looking 6-cylinder distributor with straight black boots at the cap and at the spark plug end. Includes a nicely detailed cap, base and aluminum stem.

Wire Loom Set 3D, 1/25

A package of six 3D-printed spark plug wire looms in gray. Two each 2-wire, 3-wire and 4-wire looms. Paint the

Soft Clear Line - Tube .039, 1mm OD, .020" ID

This is a soft, clear line that bends easily and smoothly.  It's able to bend at a sharp angle without kinking. It is a hollow tube with a .020" ID.