Competition Resins

1471 Kobelco Blower 1/25

A 1471 Kobelco Blower in one-piece resin.The detail is quite good and the bolts are sharp. This is a standalone blower - pulleys or other components are not included. Check out this photo for an idea...

Altered or Small Wing 1/25

A small wing for any use, but a fuel altered is an example. Has teardrop end plates. Measurements: Length: 1" Width: .62" Contains 1 resin piece, 1/25 scale

Blower 14-71, 1/16

A nice 14-71 blower with an end plate and front plate including a cogged pulley   Resin, 1/16 scale, by Competition Resins.

Carbon Fiber Style Hat, Long 1/24

A round 3-hole hat that is typically seen in carbon fiber. This is a long version.  A shorter version is also available. Molded in one piece. 1/24 scale, by Competition Resins.

Dodge 'Red Ram' HEMI Valve Covers 1/25

A pair of Dodge HEMI valve covers with lettering. DODGE and Red Ram are printed in raised lettering. The Dodge HEMI Red Ram was the most powerful stock engine in the '50's. Here are 2 real life...

Dual Nitrous , O2, Fire or Air Bottle Pair 1/25

Here are a pair of bottles that can be used for nitrous, fire, compressed air, oxygen, etc. Mount them in the interior, at the rear or ahead of the engine. Add a NOS decal found here, if this is the...

Dual Plug HEMI Valve Covers 1/25

A pair of HEMI valve covers with dual spark plug holes already drilled. Contains 2 resin pieces.

Ford C4 Transmission, 1/25

This is a nicely detailed resin cast Ford C4 tranny. The Ford C4 transmission is a lightweight, three-speed automatic transmission that was produced from 1964 to 1981. It is known for its durability...

Front Engine Fiat Dragster Body 1/25

A front engine Fiat drag racing body from the early '60's to today. Features: One-piece body Use AMT Front Engine Dragster kit for Chassis Body Color - White   One resin body with...

GM TH350 3-Speed Transmission 1/25

A nicely detailed General Motors 350 Turbo Hydromatic transmission. Molded in one piece with bellhousing. By Competition Resins, 1/25 scale

HEMI Injector Manifold 1/25

A fuel injector manifold for your HEMI engine.   Here's a fuel plumbing diagram for this manifold.The lines go to a distribution block in the center.      Velocity stacks are...

Molded Blower Belt with Pulleys 1/25

A more detailed blower belt set than found in kits. The belt shows cogs on the inside and bolt heads are found on the pulleys. Also has the blower pulley, crank pulley and idler pulley molded in....