Ignition Components

Aluminum Ignition Coils 4-Set, 1/25

A set of 4 turned aluminum ignition coils. Includes a small sheet of self adhesive aluminum which is to be cut into strips and used to mount the coils as straps. Consists of: Aluminum  Coil Boot Material Aluminum Mounting Sheet Instructions...

Spark Plug Wire, Dark Yellow .012” 1/24-1/25

A yellow spark plug wire equal in size to a real world 8mm wire. 7mm, 8mm and 9mm spark plug wires are the most common. Can also be used for larger electrical loads. The actual color is darker than the manufacturer's product photo above. Bends easily...

Pre-Wired Distributor, Red Cap, 90-Degree Boots 1/25

An authentic looking distributor with 90-degree black boots at the cap and 90-degree black boots at the spark plug end. Includes a nicely detailed cap, base and aluminum stem along with pre-assembled spark wires with boots 90-degree black boots are...

Pre-Wired Distributor, Red Cap, Straight Boots 1/25

An authentic looking distributor with straight black boots at the cap and at the spark plug end. Includes a nicely detailed cap, base and aluminum stem. Also includes a center coil wire which is indicated with its wire end bent over. Completely...

Ignition or General Wire, Yellow .014"

This bright yellow wire can be used for any electrical need. Scale Motorsport's wire is not as stiff as most other electrical wires. It is .014" diameter which is equal in real life to 5/16" or 9mm at 1/25 scale. At 1/16 scale, this wire would be...

MSD Pro Mag 44 Pre-Wired 1/25

Here's a 3D-printed MSD Pro Mag with the spark plug wires already installed.Drill a hole in your block and insert this MSD magneto. Route the wires to the spark plugs and don't forget the Spark Plug Boots, for even more detail. Check out the FREE...

Spark Plug Boots 90Deg, 3D, 1/25

A package of ten, 90-degree, 3D-printed, spark plug boots, ideally suited for the distributor cap (see photo). Enough for eight spark plugs boots at the distributor, plus two boots for the coil wire.  You will need another set of boots for the...

Spark Plug Boots 45Deg, 3D, 1/25

A package of ten, 45-degree, 3D-printed, spark plug boots.   When cutting the boot from the tree, a stem remains to insert into the head's spark plug hole (use a #70 drill bit).   The hollow end accepts Pro Tech's Spark Plug Wire. Pro...

Spark Plug Wire Loom Set, #1 1/24-1/25

This is a traditional set of wire looms. Includes four pairs of different styles, plus the typical wire separators for one to four wires. These have a good shine to them and don't need to be painted.   Hole size for spark plug wires in the 1, 2,...

Aluminum Distributor Body 1/25

This is the same Pro Tech distributor body used in their pre-wired distributors. This is the body without the spark plug wires.  You may have your own wires you want to use. A hole is provided in the top.   Contains 1 machined aluminum...

Ignition Coils and Straps 1/24-1/25

Two machined aluminum coils with photo etched straps.   By Detail Master, 1/24-1/25 scales.

Dual Style Battery 1/25

A a pair of older style batteries with 2 long filler caps on the top. Shows a strap around the batteries and long filler caps with top posts.  Here is how to wire the batteries together.   1 resin piece, by Pegasus Hobbies, 1/25 scale...