Engine Detailing

Weber Small Velocity Stacks 1/24-1/25

This will add that special detail to your Weber induction system or you may find other uses for them. They are hand turned, solid, billet aluminum stacks and there are no seams. They can be used on a standard kit engine.  The bottom diameter is ...

Blower Scoop Hardware Set 1/24-1/25

Everything you need to detail that blower and injection hat. Includes: Blower and hat hold-down platesSpark plug wire loomsAssorted bracketsLinkage fittingsIntake butterfliesBlower belt safety guardand moreStainless Steel and shiny right out of the...

Engine Bracket Accessory Set 1/24-1/25

A photo etched sheet of detailed brackets for your engine accessories. Includes brackets for an alternator, power steering, A/C, etc. You might have another accessory like an oil pump or other item that needs a bracket. This set contains two of...

Black Ferrule Fittings for Braided, Soft, Hard Lines

The latest trend in TF or FC is black fuel lines with black anodized fittings. You see them for blower injector lines, Injector-hat injection lines and more. These lines are black braided lines with black anodized AN fittings.  Typically these...

Belt Material - Serpentine, V-Belt, Accessory 1/25

This rubber, stretchable belt material can be used for many purposes. The 3" long strip is ribbed lengthwise and can be separated for the width you need.  Simply cut the length desired and glue it at the underside of the crank or other pulley...

Spark Plug Wire Loom Set 1/25

A nice set of photo etched wire looms. Spreaders are in 2, 3 and 4-hole configurations. If using soft .020" (or smaller) rubber wires, use the looms as they are. If using solid wire, It is necessary to "clean up" the holes with a .020" bit so wires will...

Flowmaster Mufflers, Pair 1/25

A pair of nicely made and realistic looking offset inlet/outlet mufflers. These are 3D-printed with FLOWMASTER in raised letters on one side. Two 3D-printed muffler clamps and a Flowmaster decal is included for each muffler. Mount the muffler upside...

4-Pulley Set, 2-Grooves, 1/25

A set of four spun aluminum V-groove pulleys. Consists of: 1 Double groove crank pulley 1 Double groove water pump pulley 1 Large single groove accessory pulley 1 Small single groove accessory pulley Belt material   NOTE: The diagrams on the...

BBC Centered Motor Plate 1/25

A more accurate motor plate than found in a kit. It is designed for those cars with a centered driveline.While this motor plate is copied after the one used in the Revell Pro-Sportsman kits, it can be used in any build with possible modification.It is...

Ferrule Fittings for Braided, Soft, Hard LInes -Silver

Perfect for simulating compression or crimp-type end-of-line fittings on NOS lines, blower injector lines, Injector-hat injection lines or carb fittings. Can also be used as radiator hose ends and carburetor 'boosters'.         ...

Holley Split Dominator & PE Details, Pair 1/25

Holley Split Dominator Ultra Detail Carb Kit with Photo Etch Air Horn and Linkage Contains 4 split carbs and PE details.   Photos of completed carbs are for illustration only. Assembly required. 3D-printed and photo etched parts by...

Liberty Transmission 1/25

This is a replica of the Liberty 5-speed Clutchless transmission. Scott, at Futurattraction, took measurements directly from a real Liberty transmission. It doesn't get any more authentic than this.   See also, a photo etched Liberty shifter...