Pro Tech 1/16 Scale

Distributor Kit 1/16

Resin distributor, shaft and boot material. The cap has 'starter' holes to drill out and insert the spark plug boot which is cut from the included material. Refer to the photo showing a completed distributor. Assembly and painting are not included...

Hex Braided Line Fittings .060

These hex fittings are compatible with the .060 diameter Braided Line and .065 aluminum hard line.   Make your own AN fittings using Pro Tech's aluminum Hex Fittings.For a realistic anodized appearance on these aluminum fitting, use Duplicolor...

Larger Detailing Wire or 1/16 Spark Plug Wire

This black wire can be used for a large gauge electrical wire for 1/25 and 1/16 scales and it's also used for 1/16 scale spark plug wire. This has a solid copper core and will maintain its shape when formed. One package contains 3' of black wire, .024"...

Hex Braided Line Fittings .080

These hex fittings are compatible with the .080 diameter Braided Line and .078 aluminum hard line.   Make your own AN fittings using Pro Tech's aluminum Hex Fittings.For a realistic anodized appearance on these aluminum fitting, use Duplicolor...

Blown Engine Fuel Injection Block 1/16

Fuel Injection Block for supercharged engines. This is the fuel block that is located behind the injector hat and behind the blower which feeds the manifold. Use Pro Tech?s .035 Braided Line along with the corresponding fittings for the fuel feed line to...

Spark Plug Boots Black 1/16

Rubber boots ready to use as is, for straight boots, or cut them and glue at a 90 degree angle for angled boots.Use in combination with your choice of color Pro Tech Spark Plug Wire.Each pack contains 8 black boots, by Pro Tech.

Small Detailing Wire

Small gauge detailing wire for ignition items, lights, gauges and other smaller electrical loads. Available in Black, Blue and Yellow. One package contains 3' x .007" diameter wire. Specify color.

Throttle Linkage 1/16

Whether it's a blown engine, injected or carbureted, these photoetched pieces will detail your throttle linkage. For the metal linkage that fit into the holes, use the .014 and .020 aluminum lines.  These are stiff enough to hold...

Aluminum Ignition Coil 1/16

Machined aluminum ignition coil with rubber boot.Use with your color choice of Pro Tech Spark Plug Cable.

MSD 6 Ignition Box 1/16

Each package contains 1 MSD 6 ignition box. The casting of this box shows the ribs and area for the MSD logo. The photo shows two Pro Tech MSD boxes with MSD labels copied from an automotive magazine and reduced. These are not included with the MSD 6...

Rod Ends/Link/Heim Kit 1/16

Cast metal parts for your suspension or throttle linkage detail.  Can be used for heim joints/rod ends in suspension areas like a 4-link rear end, panard bar or front radius rods. Use in combination with Pro Tech's Throttle Linkage kit for a...

Nut & Bolt Set - Photo Etched

Photo Etched bolt and nut flat heads,  Nut features a protruding bolt. Offered in 3 sizes to fit your needs. The dimension is measured across the flats.Mounted on a soft back so no cutting of parts is necessary (means less lost...