Shop by Manufacturer

Weld SuperLite Wheels 4-Set 1/24

A set of front and rear Weld SuperLite wheelsIncludes wheel fronts and custom open rear rings (for visible brake detail). 

Cirello Magneto Kit 1/25

This 3-piece Cirello mag is what you need for that early dragster or altered. The cap has 'starter' holes to drill out for your spark plug wires.

Aluminum Distributor Body 1/25

This is the same Pro Tech distributor body used in their pre-wired distributors. This is the body without the spark plug wires.  You may have your own wires you want to use.

GM Lap Seat Belts with PE Buckles 1/25

A set of 4 authentic looking lap seat belts with excellent photo etched buckles. Excellent addition to a muscle car, hot rod, rat rod or other early vehicle.

Tire Decal Sheet - White Goodyear 1/16

1/16 scale decal sheet for slicks in white lettering.  Yellow lettering is also available. Includes 'Goodyear', 'Eagle' and 'Goodyear Eagle' decals.  Enough for several cars.

Flowmaster Mufflers, Pair 1/25

A pair of nicely made and realistic looking offset inlet/outlet mufflers. These are 3D-printed with FLOWMASTER in raised letters on one side.

Drag Racing Parachute 1/16

Detailed Drag parachute.One per package.Resin

Carburetor Fuel Junction Block 1/16

For your single or dual carburetor setups.  Made with molded-on fittings.Use .035 Braided Lines and Fittings and large T fitting.

Front Strut Gusset Kit 1/25

These gussets are intended to add both structural as well as added detail to the upper strut mount. There are enough for approximately seven cars.

Micro Set, Setting Solution

Microscale's Micro-Set is a decal "setting" solution that softens decals and improves adhesion plus lets the decal conform to the model's surface. To apply Micro Set: Use a s

Centerline Wheels 4-Set 1/24

A set of front and rear Centerline wheelsIncludes wheel fronts and custom open rear rings (for visible brake detail). Rear wheel is .73" OD. O

3D-Printed 'Street' 4bbl Carburetor 1/25

Highly detailed Holley Street 4-bbl Carburetor with a choke plate in the closed position.With single or dual carbs, you'll need a Fuel Junction Block (see 1/25 SCALE/ENGINE RELATED/FUEL MANAGEMENT).