Shop by Manufacturer

Injector Stacks - Small 1/24-1/25

Smaller, polished aluminum injector stacks for a Hilborn style induction system. Pack contains 8 stacks, polished aluminum with a flared top. . The stacks are hollow with a 'pin' at the bottom for easy mounting Dimensions per back of...

Dragster Wire Wheels 20" with Light Shield 1/25

Real wire wheels with real spokes and one wheel has a 'light shield' timing disc on one side for newer/nostalgia dragsters. The light shield provides a larger area to trigger the staging lights and the timing lights at the end of the strip. Fully...

BBC Offset Motor Plate 1/25

A more accurate motor plate than found in a kit. It is offset for those cars with an off-center driveline.While this motor plate is copied after the one used in the Revell Pro-Sportsman kits, it can be used in any build with possible modification.It is...

Rear Tube Frame/Clip .800" Wide 1/25

A round-tube rear frame clip ready to install.  It's 3D printed in FUD material. Dimensions are:Frame width = .800"Frame tube diameter = .080"Cross member diameter = .080"Overall length = 2.55" Two other frame clips widths are available in .700"...

Wheelie Bar Housing Kit 1/16

Here is a Wheelie bar wheel housing kit designed for today's PM, FC, ADRL, SS, and others. Includes PE wheel housing and PE and resin wheels which must be assembled. Fabrication required. Does not include mounting hardware.   Assembly and...

Aluminum Hard Line .032, .81mm Dia

This aluminum hard line equals the following equivalent 1:1 size at each scale.1/25 scale = 3/4"1/16 scale = 1/2"1/12 scale = 3/8"1/8 scale   = 1/4"Depending on your scale, typical uses are fuel and oil lines. Fuel lines from the fuel pump to the...

Valve Cover T-Bolts, Photoetched 1/25

Add realism to your engine bay with these Valve Cover T-Bolts. They're long valve cover bolts that have a T shape at the top.There are enough valve cover bolts here for a few cars. One set photoetched, by Pro Tech.

Gasser & New Graphics Decal Sheet #2, 1/25

1/25 scale mini decal sheet with Gasser graphics plus a few sponsors for newer cars or rat rods. Includes (2 of each)  M&H Racemaster "Gas Chamber" "The STRIP Teaser" Moon Eyes New York National Speedway logo "Rapid Ronnie" A/Gas,...

Cross-Ram Manifold & Carbs 1/25

A cross-ram & carburetor package.All items have locating pins for easy alignment. Consistis of: 1 Cross-Ram manifold 2 4bbl carbs 1 Air cleaner   1/25 scale by Competition Resins

Hand Brake Levers for for PM or TF 1/16

A set of Hand Brake Levers for your Dragster or Funny Car.  Adds realism and detail to your build. Contains two brake levers with additional hand grips. Place a small piece of styrene between the lever grip and added grip for thickness. Photo...

Barry Grant DEMON 4bbl Carburetor 1/16

Detailed Barry Grant 4bbl CarburetorWith single or dual carbs, you'll need Pro Tech's 1/16 scale Fuel Junction Block.Also see the Braided Lines, Hard Lines, Soft Lines and Fittings along with the T fitting to split the fuel line to each carb. One...

Braided Stainless Steel Cable, Various Sizes

This makes an excellent steel braided line.  It's nylon coated 7-strand stainless steel which can be bent really tight without kinking I've used it for a parachute-release cable from the cockpit parachute release lever to the parachute and it...