Shop by Manufacturer

P/M Tubular Full Chassis, Long Nose, 1/25

A complete one-piece 3D-resin-printed chassis. This was designed to fit Competition Resin's 1953 Corvette Pro Mod body, but the body is no longer being made. It may fit your needs too (see dimensions below). This chassis is for bodies...

Engine Oil Weathering

This will give you the look of fresh oil on any type of engine or metal object.   This enamel based paint just needs to be painted on. Apply with a brush in different layers of different intensities for the most realistic effects...

6 Drill Bit Pack #60 - #70

Here is a plastic tube containing 6 small drill bits - probably those you break so easily. 6-piece pack of fine high speed steel drill bits Includes six drills #60 through #70. Used with: wood, resin, jewelry, walnut, amber, beeswax, olive nut,...

Pro Stock Decal Sheet, Glidden-Allen, 1/25

Although this sheet is made for the '72 Glidden & Allen Pinto, it has the sponsors and graphics for an era-specific car.   The '72 Pinto body can be found here. Includes: Hurst Accel Hooker Headers Holley Valvoline NHRA Mr Gasket...

Fairmont 1978 Dyno Don Decals1/25

1978 Dyno Don Fairmont DecalsThese decals represent the livery that Dyno Don's '78 Fairmont wore the year after he won the 1977 NHRA Pro Stock Championship with his Mustang II.  Decals by Chuck Naylor.  This decal set is designed to fit...

Street Rod Gauge Background Set #2, Colored 1/25

Add some color to those street rod gauges.For use only with Street Rod Gauges Set #2 (black or white).Contains printed material, 4-colors, by Pro Tech.

Flathead Engine-Late Model, Stock, 1/25

This Flathead engine is from a kit and is a stock version. It is a late model (1945-1953) engine with the radiator hoses located at the front of the heads and lowered water pumps. Instructions included. Check out these pulleys, fan blades or these air...

Dual Plug Distributor Set, Pre-Wired, Red Cap Yellow Wire 1/25

Here's a pair of distributors that includes a dual-drive. Pre-wired with yellow spark plug wires.           PHOTO OF REAL SETUP Contains 2 Red Distributor Caps with yellow wires. 2 Distributor Bodies Dual Distributor...

Distributor Vacuum Can, 1/25

Here is a small, but essential part of an ignition system. This vacuum can is necessary for engine timing. It is part of the total timing, where the distributor is adjusted fore-aft to advance or retard timing. This can gets its vacuum from a tube that...

Pre-Wired 4-cyl Distributor, Black Cap, 1/25

An authentic looking 4-cylinder distributor with straight black boots at the cap and at the spark plug end. Includes a nicely detailed cap, base and aluminum stem. Also includes a center coil wire which is indicated with its wire end bent over...

Black Hard Line .020", .5mm OD

This black hard line equals the following equivalent 1:1 size at each scale.1/25 scale = 1/2"1/16 scale = 1/4" or 5/16"1/12 scale =1/4"1/8 scale  = 1/8"Typical uses are small oil, vacuum and fuel lines, especially fuel & nitrous delivery at the...

'67-'68 Camaro P/M-P/S Tubular Chassis, 1/25

A complete one-piece 3D-resin-printed chassis to fit a first gen Camaro or Firebird.  This was custom designed for Ronald Mikol's '68 Firebird. If you're using a different body, email me with the body you intend to use to obtain measurements for a...