Pro Tech

Radiator Flex Fan, 17" Dia 1/25

Add another element of detail to your engine bay.A pair of 17" diameter Flex Fans.      Contains 2 photoetched fans per package in 1/25 scale, by Pro Tech.

Rod Ends/Link/Heim Kit 1/16

Cast metal parts for your suspension or throttle linkage detail.  Can be used for heim joints/rod ends in suspension areas like a 4-link rear end, panard bar or front radius rods. Use in...

Roll Bar Padding 1/16

Rubber tubing for roll bars.Can also be used for other larger water/coolant hoses.At 1/16 scale, this would be equal to 1.5" ID and 3.5" OD.At 1/12 scale, this would be equal to 1...

Roll Bar Padding 1/25

Rubber tubing for roll bars.   Dimensions are as follows: 1/8" OD 1/16" ID 1/32" Wall thickness   Can also be used for other larger water/coolant hoses.     Four, 2...

Round 14" Aluminum (Custom Style) Air Cleaner 1/25

This machined aluminum air cleaner is equal to a real world 14" w x 3" h.  It would be typically be found on a single carburetor.Includes photoetched wing nut and simulated filter element. The...

Round 4" Aluminum (Nostalgia Style) Air Cleaner 1/25

This machined aluminum air cleaner measures 4"w x 2"h. It would be typically be found on a single carburetor.Includes photoetched wing nut and simulated filter element. The photo shows a 14" air...

Round 9" Aluminum (Edelbrock Style) Air Cleaner 1/25

This machined aluminum air cleaner measures 9"w x 2"h. It would be typically be found on a single carburetor. Modeled after an Edelbrock air cleaner.Includes photoetched wing nut and simulated filter...

Round 9" Aluminum Air Cleaner 1/25

This machined aluminum air cleaner measures 9"w x 2"h. It would be typically be found on a single carburetor.Includes photoetched wing nut and simulated filter element. Photo of a 14" air cleaner...

Small Detailing Wire

Small gauge detailing wire for ignition items, lights, gauges and other smaller electrical loads. Available in Black, Blue and Yellow. One package contains 3' x .007" diameter wire. Specify color.

Spark Plug Boots 45Deg, 3D, 1/25

A package of ten, 45-degree, 3D-printed, spark plug boots.   When cutting the boot from the tree, a stem remains to insert into the head's spark plug hole (use a #70 drill bit).   The...

Spark Plug Boots 90Deg, 3D, 1/25

A package of ten, 90-degree, 3D-printed, spark plug boots, ideally suited for the distributor cap (see photo). Enough for eight spark plugs boots at the distributor, plus two boots for the coil wire...

Spark Plug Boots Black 1/16

Rubber boots ready to use as is, for straight boots, or cut them and glue at a 90 degree angle for angled boots.Use in combination with your choice of color Pro Tech Spark Plug Wire.Each pack...