Black Coated Hard Line .016", .4mm Dia

This hard line has a glossy black coating over a wire and lends a different look to your build. It holds its shape and can be bent at tight angles without kinking. Equivalent 1:1 size at each scale. 1/25 scale = 3/8"1/16 scale = 1/4"1/12 scale =...

Micro Sol, Setting Solution

Microscale's Micro-Sol is a decal "setting" solution for the most difficult irregular surfaces to be found on models. It allows the decal to drape down onto the surface of the model, conforming perfectly to surface irregularities without distortion...

Micro Set, Setting Solution

Microscale's Micro-Set is a decal "setting" solution that softens decals and improves adhesion plus lets the decal conform to the model's surface. To apply Micro Set: Use a soft flat artist's brush and apply Micro Set where you are going to apply the...

Model Master Gelb RLM 04 Acrylic, 1/2oz Bottle

This can be thinned, in order to flow better, with an Acrylic Thinner.   By Testor's, one 1/2oz bottle.

Fenton/Anson Front Wheels 1/25

A pair of 5-slot Fenton (or Anson) front wheels. Popular on gassers, super stock or pro stock cars. These are similar to the Gasser Front Wheels, but these have larger slots  OD = .67", 17mm Overall Width = .19", 5mm   The wheels that will...

Wide Rear Steel Wheel Pair 1/25

A pair of deep rear wheels. These are stock looking steel wheels with lug nuts, except they're wide to hold big rubber. Great for street racers, early Super Stock or Pro Stock and Rat Rods. Width/Depth = .33" (11/32")   Contains 2 resin wheels by...

Dual Quad Tunnel Ram Manifold 1/25

Set a pair of Dominator or Demon carbs on top of this manifold. Make sure you have room under your hood or cut a hole in the hood to allow for the height. Overall height is .43" (7/16"). Here's a photo of a real dual quad setup byRich Vitiritti. ...

S.C.O.T Blower 1/25

Here's a special blower for that Flathead engine. S.Co.T. is an abbreviation for 'Supercharger Company of Turin' (Torino), Italy. It was one of the most popular "roots" style blowers in the 1950's and popular today on Street Rods and Rat Rods...

Holley Dominator Carburetor (Pair) 1/25

A pair of nicely detailed Holly Dominator 4-bbl Carburetors. With single or dual carbs, you'll need a Fuel Junction Block (see ENGINE DETAILING). Also see the Braided Lines, Hard Lines, Soft Lines and Fittings along with the SMALL or LARGE 'T' fitting...

GM TH350 3-Speed Transmission 1/25

A nicely detailed General Motors 350 Turbo Hydromatic transmission. Molded in one piece with bellhousing. By Competition Resins, 1/25 scale

Pirelli Type Small Front Racing Tires 1/25

These front tires will work for a Gasser as well as a Pro Mod or street racer. These are slightly smaller than the Futurattraction Front Runner tires. These are semi hard tires but still flexible. Measurements:Outside Diameter = .98"Overall width = ...

Good Year Dragster Slicks 1/25

These are labeled '60's Goodyear Dragster Slicks but depending on the size you want, these will work for any racer. "Good Year" is in raised letters on both sides. These are slightly smaller than the Comp Resins' Pro Stock slicks. These are fairly...