Here is a complete, realistic appearing, coil over shock kit, with all of the parts needed to detail your suspension.

Kit includes:   

• 3D-printed 2-piece shock bodies
• Resin lower extensions
• RB Motion rod ends
• Nickel-silver lower spring adjusters
• Aluminium upper spring retainers with a machined spring centering pad and a stepped hole.
• .125" OD coil springs
• .032" stainless steel piston shafts (must be cut to length)
• Spring centering discs
• Alignment pins
• Instructions

It consists of 18 pieces, 9 per shock.   

HELPFUL HINTS:

The upper retainer hole is .020" in diameter; the lower one is .033".  This allows the builder to use the included pin(s) to attach/retain the upper mounting point as a stud mount (pin through the floor, frame rail or cross member).  The .020" stepped portion of the hole can be drilled out, which will permit the stainless tube to protrude through the retainer and can serve the same purpose at the thru-pin.  Doing this should permit the builder to use the full-length tube, otherwise it will require shortening.  The builder can disregard the small, smooth discs included with the PE lower spring adjusters.  For clarity, please see the assembly diagram.

Assembly required. Photo etched, steel and 3D-printed parts, 1/25 scale.