Drive Train & Chassis

Dana - Narrowed Rear End & Brake Kit 1/25

Here is a complete Dana narrowed rear end with brakes. Overall with between axle tube ends is 1-7/8" Kit includes: Narrowed housing Rear cover Housing ends including one spare Resin brake hats Resin calipers PE drilled rotors PE...

Brake Kit - Rear, Drilled Rotor .125" Spindle Diameter 1/25

This is the same rear end brake set as Futurattraction's FA-C-ROT-DR2R-063, except this rotor has a larger .125" ID hole. This allows for the hubs and rotors to slide over Futurattraction's axle housing and gives more gluing surface where they are...

Wheelie Bar Housing Kit 1/25

Here is a Wheelie bar wheel housing kit designed for today's PM, FC, ADRL, SS, and others. Includes PE wheel housing and PE wheels which must be assembled. 3D-printed wheels are also included along with 2 pieces of telescoping rods and two hex pins...

Nut & Bolt Set - Photo Etched

Photo Etched bolt and nut flat heads,  Nut features a protruding bolt. Offered in 3 sizes to fit your needs. The dimension is measured across the flats.Mounted on a soft back so no cutting of parts is necessary (means less lost...

Wheelie Bar Single X Frame, 1/25

Lower Wheelie Bar Frame - Single X Design. This is the frame only and does not include the Wheelie Bar Housing Kit or mounting/structural means. Building wheelie bars in 1/25th scale is challenging.  It can be difficult to get longitudinal tubing...

Rack & Pinion Set, Medium 1/25

 A complete Rack & Pinion set for your chassis. This fits a chassis that is about .090" wide (outside dimension). Consists of: 3D printed steering rack (0.85" overall length w/o boots, mounts are .60" wide.Two rubber bootsStainless steel...

Spindle Wheel Front Strut Kit, Slotted Rotors 1/25

This strut front end kit is made to accommodate spindle mounted wheels. The nose of the strut body is designed to center in the spindle cap and includes 3D-printed hubs to fit to the back side of the wheel. Also available is a Wishbone set that will...

P/M-P/S Tubular Full Chassis 4-3/4" Wheelbase, 1/25

A complete one-piece 3D-resin-printed chassis. This was designed to fit Competition Resin's Pro Mod - Pro Stock Camaro body, but the body is no longer being made. It may fit your needs too (see dimensions below). Email me with the body you...

Forward Frame Rail & R&P, .750” Wide, 1/25

 Building your own chassis with a front strut suspension? This Forward Frame Rail will save you a ton of time.This is a one-piece, 3D-printed, front frame and doesn't need any assembly, plus it has a separate rack and pinion with boots. It...

Liberty Transmission Shifter Lever Set 1/25

You need a set of these Liberty shifters for your Door Slammer or other drag car.  Adds realism and detail to your build. Contains set of levers, brackets, linkage and instructions..   Photo etched, .015" nickel-silver plate. 1/25 scale.

‘70’s Vega P/S Interior & Chassis Kit, 1/25

Here is an interior and chassis set for a ‘72-‘74 Ford Vega. This fits Comp Resins’ P/S Vega resin body found here. Kit includes Interior Tub       With tubbed wheel wells Chassis       Use...

Brake Kit, Slotted Rotor .125" - Rear 1/25

A detailed complete rear end brake set. This slotted rotor set is designed to work with a .125" diameter kit axle but allows the use of separate calipers and PE brackets, for more realism. Kit includes: 3D calipers (2 pieces per...