Fuel Management

Holley Dominator & PE Details, Pair 1/16

Holley Dominator Ultra Detail Carb Kit with Photo Etch Air Horn and Linkage Contains 2 carbs and PE details.   Photo shows completed carb and is for illustration only. Assembly required. Resin and photo etched parts by Futurattraction, 1/16...

Throttle Return Spring, 1/16

A small spring to simulate a throttle return spring. This is a pretty tight spring which would have the throttle in a closed position. Made of stainless steel and measures .07" OD x .25" long. Contains a loop on one end and can be cut to length...

Injector Butterfly Set for Competition Resins Shotgun Hat 1/16

These Butterflies are finely detailed showing the cross shaft and screws holes for each butterfly disc. They are made to fit the Competition Resins 2-Hole Shotgun injector hat (part #148).  Click here to see the 1/16 injector hat...

Shotgun 2-Hole Injector Hat 1/16

Contains 1 'Shotgun' type 2-hole resin injector hat. See also, photo etched butterfly discs made for this injector.   Resin, 1/16 scale.

Blower Restraint Plate, 1/16

This restraint plate sits under the blower and restraint straps would fasten to the slots and go over the blower to hold it down in the event it would blow up. It is universal to all blowers.   This photo etched piece is etched out of .016"...

Sullivan Flat-Welded Fuel Tank 1/16

A Sullivan flat-welded fuel tank. Contains 1 resin tank, 1/16 scale

Blower 14-71, 1/16

A nice 14-71 blower with an end plate and front plate including a cogged pulley   Resin, 1/16 scale, by Competition Resins.

Soft Line - Red .012", .30mm OD

This is a small, solid, flexible, deep red line.  It can bend at a fairly sharp angle without kinking.See Size A1 Ferrules for this soft line. This soft line equals the following equivalent 1:1 size at each scale.1/25 scale = 5/16"1/16 scale...

Holley Dominator Multi-Media, Pair 1/16

Holley Dominator multi-piece Carb Kit with Photo Etch Air Horn and Linkage Carbs separate into separate main body, metering blocks and float bowls for extra detailing! The carb bodies are based off 3D-printed masters. They are supplemented with...

RBS Square 4-Hole Hat with Butterflys, 1/16

This is a CAD designed replica of an RBS Square 4-Hole Injector Hat, in 1/16 scale. The intake openings are hollowed out. Small holes across the front openings are provided for a rod to connect the butterflys to your throttle linkage and barrel valve...