Fuel Management

Soft Clear Line - Hose .005", .13mm OD

This is my smallest clear line.  You can barely see it, but if you need a really small clear line, this is it.This could be used for a 1/25 radiator overflow tube, small carburetor fuel lines, or...

Carburetor Fuel Junction Block 1/16

For your single or dual carburetor setups.  Made with molded-on fittings.Use .035 Braided Lines and Fittings and large T fitting.

Soft Line - Hose .005", .12mm OD

This is the smallest black soft line I have. This is a shiny black nylon line. It is slightly springy and can be bent at sharp anglesThe

Soft Line - Hose .008", .20mm OD

This is a small black twisted multi-fiber line. It is very flexible and can be bent at sharp anglesThe OD dimension is .008" or .20mm. 

Black Cable .015", .38mm OD

This is a black nylon-coated stainless steel multi-strand wire. It is slightly springy and can be bent at sharp angles. This would make a great 'black jacket' release cable or throttle cable.The OD...

Small Multi-Use Springs, Throttle/Hood/Brake (pair)

Two small springs for throttle linkage or to hold those semi tractor air hoses.Depending on your scale, these could be used for brake pad springs or hood-hinge springs.Spring length is .25"Contains...

Barry Grant DEMON 4bbl Carburetor 1/16

Detailed Barry Grant 4bbl CarburetorWith single or dual carbs, you'll need Pro Tech's 1/16 scale Fuel Junction Block.

Throttle Return Spring, 1/16

A small spring to simulate a throttle return spring. This is a pretty tight spring which would have the throttle in a closed position. Made of

RBS Square 4-Hole Hat with Butterflies, 1/25

This is a CAD designed replica of an RBS Square 4-Hole Injector Hat, in 1/25 scale. The intake openings are hollowed out. Small holes acro

Holley Dominator & PE Details, Pair 1/16

Holley Dominator Ultra Detail Carb Kit with Photo Etch Air Horn and Linkage

Injector Butterfly Set for Shotgun Hat 1/16

These Butterflies are finely detailed showing the cross shaft and screws holes for each butterfly disc. They measure .312" diameter and may fit your particular injector.

Blower Restraint Plate, 1/16

This restraint plate sits under the blower and restraint straps would fasten to the slots and go over the blower to hold it down in the event it would blow up. It is universal to all blowers.