Fuel Management

Inline Injectors 1/16

Mark Johnson is a master at designing, and resin casting 1/16 scale parts. This set of four inline injectors is excellently detailed. This injector set is normally found on earlier blown engines. It would sit between the blower and the scoop, like...

Throttle Return Spring, 1/16

A small spring to simulate a throttle return spring. This is a pretty tight spring which would have the throttle in a closed position. Made of stainless steel and measures .07" OD x .25" long. Contains a loop on one end and can be cut to length...

Soft Line - Red .012", .30mm OD

This is a small, solid, flexible, deep red line.  It can bend at a fairly sharp angle without kinking.See Size A1 Ferrules for this soft line. This soft line equals the following equivalent 1:1 size at each scale.1/25 scale = 5/16"1/16 scale...

RBS Square 4-Hole Hat with Butterflys, 1/25

This is a CAD designed replica of an RBS Square 4-Hole Injector Hat, in 1/25 scale. The intake openings are hollowed out. Small holes across the front openings are provided for a rod to connect the butterflys to your throttle linkage and barrel valve...

RBS Square 4-Hole Hat with Butterflys, 1/16

This is a CAD designed replica of an RBS Square 4-Hole Injector Hat, in 1/16 scale. The intake openings are hollowed out. Small holes across the front openings are provided for a rod to connect the butterflys to your throttle linkage and barrel valve...

Blower Belt, 1/16

This 1/16th scale ribbed blower belt fits Revell Hemi engines, as well as other engines, but the pulley cogs may be different.  It is cast out of urethane rubber and stretches enough to fit nicely over the kit pulley setup.  It can fit...

Blower Restraint Plate, 1/16

This restraint plate sits under the blower and restraint straps would fasten to the slots and go over the blower to hold it down in the event it would blow up. It is universal to all blowers.   This photo etched piece is etched out of .016"...

Holley Dominator Multi-Media, Pair 1/16

Holley Dominator multi-piece Carb Kit with Photo Etch Air Horn and Linkage Carbs separate into separate main body, metering blocks and float bowls for extra detailing! The carb bodies are based off 3D-printed masters. They are supplemented with...

Soft Line - Hose .011", .29mm OD

This is a shiny black nylon line. It is slightly springy and can be bent at sharp anglesThe OD dimension is .008" or .20mm.  This soft line equals the following equivalent 1:1 size at each scale.1/25 scale = 9/32"1/16 scale = 1/12 scale =1/8...

Soft Line - Hose .005", .12mm OD

This is the smallest black soft line I have. This is a shiny black nylon line. It is slightly springy and can be bent at sharp anglesThe OD dimension is .0047" or .14mm.  Typical uses are small oil lines, vacuum and fuel lines, especially fuel...

Blower 14-71, 1/16

A nice 14-71 blower with an end plate and front plate including a cogged pulley   Resin, 1/16 scale, by Competition Resins.

Soft Clear Line - Hose .005", .13mm OD

This is my smallest clear line.  You can barely see it, but if you need a really small clear line, this is it.This could be used for a 1/25 radiator overflow tube, small carburetor fuel lines, or other clear line needed.  This soft line is easy...