1/16 Scale

Liberty Transmission Shifter Kit 1/16

This is a standalone shifter kit for a Liberty transmission.                 Photo of real shifter.              I'll include a print of this exploded view to help with the...

US Flag Set, All Scales

US Flag Set, 50-Stars, in four different sizes. This isn't a decal. The flags have adhesive backing.. Contains: One 1.5" x .75"  (40 x 20 mm) two sides flag One  .6 x .3" (16 x 8 mm) two-sides flag Three .6 x .3" (16 x 8 mm) flag Three ...

Weld AlumaStar 5-Spoke Narrow Front Wheel, 1/16

A 3D-printed reproduction of Weld's AlumaStar 15" x 3.5" front wheel. The five spokes are centered in a .28" width wheel with a 1.04" diameter rim. The raised center of the rim OD will fit Futurattraction's 1/16 scale Front Runner tire.   One...

426 HEMI Front Motor Plate, 1/16

A photo etched front motor plate for a Revell HEMI engine. Includes 4 chassis tabs for bolting on to the motor plate. Sized to fit an approximate chassis width of 1.16" (center to center). Will replace existing Revell kit mounts. For the best fit,...

Small Block Engine Crank Trigger 1/16

Here is a Crank Trigger kit, for a small block engine and especially for the small block Chevy. Includes crank trigger wheel, sensor mount and adjustable sensor mounting bracket. A crank triggered ignition system can make more horsepower than a...

Front End Mounting Brackets 1/25

These brackets are intended to simulate the mounting brackets used to locate removable front ends from drag or other styles of cars.   Photo etched, 1/25 scale, by Futurattraction.   Photo Etched, (2 pr) 

Drag Racing 4-Tire Set - Slicks and Fronts, 1/16

An entire set of slicks and front tires for your drag racing machine. Made of a semi-hard rubber and won't stretch too much. They are solid but very light for their size. The slicks have a nice rounded sidewall and are made in two pieces. The rear...

Liberty Transmission 1/16

Liberty 5-speed clutchless transmission for Pro Stock or other race class up to 3000 HP. Scott, at Futurattraction, took the measurements right off of a real Liberty tranny.  You can't get more realistic than that.   Here's the transmission...

Under Hood Insulation, Trunk Matting

When you open the hood of your earlier street machine, custom or stock car, do you see the insulation that came from the factory?They used to add this to keep the noise down. Now you can put it back in. It can also be used in the trunk.A few could be...

Coil Over Shock Kit 1/16

Here is a complete, realistic appearing, coil over shock kit, with all of the parts needed to detail your suspension. They are static and once assembled are not movable. These coil-overs replicate 15" Penske 8300 double-adjustable...

Front Strut Gusset Kit 1/16

These gussets are intended to add both structural as well as added detail to the upper strut mount. There are enough for approximately seven cars. These gussets are intended to fit around a 9/64" (.140)" diameter upper strut mount.    ...

Thermostat Housing 1/16

Here is a detail item you won't find everywhere - a thermostat housing for any engine. A .157" rubber line (equal to a 1:1 size of 2-1/2" radiator hose) will fit over the outlet neck found here.   Contains one thermostat / water neck...