Pro Tech

3D-Printed 'Street' 4bbl Carburetor 1/25

Highly detailed Holley Street 4-bbl Carburetor with a choke plate in the closed position.With single or dual carbs, you'll need a Fuel Junction Block (see 1/25 SCALE/ENGINE RELATED/FUEL MANAGEMENT)...

3D-Printed 4bbl Carburetor 1/25

Highly detailed Holley Street/Strip 4-bbl Carburetor.With single or dual carbs, you'll need a Fuel Junction Block (see 1/25 SCALE/ENGINE RELATED/FUEL MANAGEMENT). Also see the Braided Lines, Hard...

5-Point Racing Harness 1/16

5-Point Racing Harness with metal cast buckles and ready to use harness material.Not your flat photo-etched hardware. This is cast for 3D texture and detail. Pro Tech's own design makes it easy to...

5-Point Racing Harness 1/25

Pro Tech's 5-Point Racing Harness with photoetched buckles and ready to use harness material.                         ...

Aluminum Distributor Body 1/25

This is the same Pro Tech distributor body used in their pre-wired distributors. This is the body without the spark plug wires.  You may have your own wires you want to use. A hole is provided...

Aluminum Gas Cap 1/16

Excellent detail for your race car fuel cell, hot rod Moon tank and other tanks like an oil tank on a Funny Car, Pro Mod or Dragster.Can also be used for a radiator cap, engine oil breather cap or...

Aluminum Ignition Coil 1/16

Machined aluminum ignition coil with rubber boot.Use with your color choice of Pro Tech Spark Plug Cable.

Aluminum Ignition Coil 1/25

Machined aluminum ignition coil with rubber boot.Use with your color choice of Pro Tech Spark Plug Cable. Coil shown with Pro Tech's distributor kit, flex fan, spark plug wires, spark plug boots,...

Aluminum Oil Filter 1/16

Each package contains 1 filter. Machined aluminum  

Barrel Valve 1/16

A barrel valve is located on the left side of a supercharged engine injector hat. The fuel input is via a braided line from the fuel pump and 2 outlet braided lines go to 2 fuel junction blocks (see...

Barry Grant DEMON 4bbl Carburetor 1/16

Detailed Barry Grant 4bbl CarburetorWith single or dual carbs, you'll need Pro Tech's 1/16 scale Fuel Junction Block.Also see the Braided Lines, Hard Lines, Soft Lines and Fittings along with the T...

Barry Grant DEMON 4bbl Carburetor 1/25

Detailed Barry Grant 4-bbl Carburetor.With single or dual carbs, you'll need a Fuel Junction Block (see ENGINE DETAILING).Photo shows a real Demon carb for reference only. Also see the Braided Lines,...