Drive Train & Chassis

Rear Tube Frame/Clip .800" Wide 1/25

A round-tube rear frame clip ready to install.  It's 3D printed in FUD material. Dimensions are:Frame width = .800"Frame tube diameter = .080"Cross member diameter = .080"Overall length = 2.55" Two other frame clips widths are available in .700"...

Weld Beads 3D - Arc 1/25 - 1/24

Weld beads in 3D by Archer Surface Details. Use them wherever welds would be found, like: headers, intake manifolds/air boxes, frames, roll bars and the list goes on. These arc-weld beads are the typical hand-held welds you'd make yourself. ...

Coil Spring .375" x .125" (pair) 1/25

These springs are used on Fururattraction's Coil Over Shock kits, but can be used in any suspension system that requires the dimensions below. The ends are ground flat.    Total height is .375" Outside diameter is .125" Wire diameter...

Coil Spring .250" x .125" (pair) 1/25

These springs are used on Fururattraction's Front Strut kits, but can be used in any suspension system that requires the dimensions below. The ends are ground flat.    Total height is .250" Outside diameter is .125" Wire diameter is ...

Brake Kit, Drilled Rotor - Rear 1/25

A detailed complete rear end brake set. This drilled rotor set is designed to work with a .063" diameter kit axle but allows the use of separate calipers and PE brackets, for more realism. Kit includes: 3D calipers (2 pieces per...

Sportsman 4-Link Suspension Kit for Revell 1/25

4-Link multi-media kit replicates styrene 4-link in Revell top sportsman kit. Fits Revell kit rear ends or rear ends with .125" OD axle housing with no back brace. Kit includes chassis and rear end housing brackets, four .050" OD stainless steel...

Dana 60 Rear End 1/25

A hard-core Dana rear end.      Photo of real Dana 60 by Moser                 Photo of a real Dana 60 by Strange     Contains 1 resin piece, 1/25 scale

GM 700R Transmission 1/25

A General Motors trick 700R automatic transmission. Contains 1 resin transmission, 1/25 scale

Dual Nitrous , O2, Fire or Air Bottle Pair 1/25

Here are a pair of bottles that can be used for nitrous, fire, compressed air, oxygen, etc. Mount them in the interior, at the rear or ahead of the engine. Add a NOS decal found here, if this is the intended use for these bottles.  The 'small' size...

Lenco Transmission 4-Speed/Reverse, Manual Shift 1/25

This is a complete Lenco transmission configured for 4-speeds with reverse. It is a one-piece unit including 3D-printed shifter levers (the shifter levers are really small and easy to loose). The front section contains gears 1 and 2 and is...

4-Link Pro Mod Suspension Kit (also fits Dana) 1/25

This kit represents the current heavy duty style of 4-link kits found on high horsepower Pro Mod drag cars. Also included in this kit is anti-roll bar linkage and arms. No torsion bar/tube is included and must be scratch built. Included are four .050"...

Lenco Shifter Lever Set 1/25

You need a set of these Lenco shifters for your Pro Mod or other drag car.  Adds realism and detail to your build. Contains set of levers, brackets, linkage and instructions.. Make sure you click on the product photo above, to enlarge it, to...