Engine Detailing

Water Pump, Alternator, Timing Cover, Crank Pulley, 1/25

Here it is, all in one 3D-printed piece for a BBC or SBC. A timing cover with the crank pulley along with a water pump (and pulley), alternator and rubber V-belt.

Dry Sump Oil Reservoir, 1/25

This dry sump oil reservoir is modeled after a Moroso 22612.

Radiator Shroud Set 1/25

Here is a combination of a resin radiator, shroud and and fan-surround.    Radiator dimensions: Width at the

Small Block Ford Engine Crank Trigger 1/25

Here is a Crank Trigger kit, for a small block Ford engine. Includes crank trigger wheel, sensor mount and adjustable sensor mounting bracket.

Round 9" Aluminum Air Cleaner 1/25

This machined aluminum air cleaner measures 9"w x 2"h. It would be typically be found on a single carburetor.Includes photoetched wing nut and simulated filter element.

Engine Pulley Set, Star Design, 1/25

A different type of pulley set. These are photo etched and the pieces stack to give the pulley depth. You could also cut a piece of round styren

Engine Bay Tin, '69 Camaro 1/25

This tin work fits Revell's 1969 Camaro. Great for that pro street or race car look!t This is a Tight fit and may require a bit of filing on the

Battery Manufacturer Decals 1/25

Contains a pair of 16 different battery brands for a total of 32 decals. Names like: Exide

Blower Starter Bracket, 1/16

Unless your blown engine has its own starter, you'll need to start it with a blower starter. This bracket holds the blower starter and will add that special touch of detail to your engine.

Pro Street License Plate Decal 1/25

A pair of license plate decals with PRO STREET written on the face. These are New Your plates with a red Statue of Liberty on the left side. The

Valve Cover Wing-Bolts, Photoetched 1/25

Add realism to your engine bay with these Valve Cover Wing-Bolts. They're long valve cover bolts used for decoration.There are enough valve cover bolts here for a few cars.

Engine Pulley Set, Circle Design, 1/25

A different type of pulley set. These are photo etched and the pieces stack to give the pulley depth. You could also cut a piece of round styren