Engine Parts & Detailing

671 GMC Blower 1/16

A 671 blower for early dragsters or for a street machine.Blower pulley is attached to the front plate.The detail is quite good and the bolts are sharp. Check out this photo for an idea of which blower you need. Contains 2 resin pieces.

Holley Dominator & PE Details, Pair 1/16

Holley Dominator Ultra Detail Carb Kit with Photo Etch Air Horn and Linkage Contains 2 carbs and PE details.   Photo shows completed carb and is for illustration only. Assembly required. Resin and photo etched parts by Futurattraction, 1/16...

Injector Butterfly Set for Competition Resins Shotgun Hat 1/16

These Butterflies are finely detailed showing the cross shaft and screws holes for each butterfly disc. They are made to fit the Competition Resins 2-Hole Shotgun injector hat (part #148).  Click here to see the 1/16 injector hat...

Shotgun 2-Hole Injector Hat 1/16

Contains 1 'Shotgun' type 2-hole resin injector hat. See also, photo etched butterfly discs made for this injector.   Resin, 1/16 scale.

Blower Restraint Plate, 1/16

This restraint plate sits under the blower and restraint straps would fasten to the slots and go over the blower to hold it down in the event it would blow up. It is universal to all blowers.   This photo etched piece is etched out of .016"...

MSD Pro Mag 44 Magneto 1/16 Scale

Brand new from Flash Point - MSD Pro Mag 44 magneto.   The photos show the parts included along with a completed and painted example.  Paint and decals are not included.Resin - 4 pieces. Assembly required.

Detailing Wire .0075", Dark Blue

Small dark blue wire to be used for ignition wiring, computer connections, gauges, etc. Bends easily and holds its shape.Also available in the following colors: BlackWhiteRedLight BlueYellow One package of wire .0075" x 3', by Detail Master

Blower 14-71, 1/16

A nice 14-71 blower with an end plate and front plate including a cogged pulley   Resin, 1/16 scale, by Competition Resins.

Under Hood Insulation, Trunk Matting

When you open the hood of your earlier street machine, custom or stock car, do you see the insulation that came from the factory?They used to add this to keep the noise down. Now you can put it back in. It can also be used in the trunk.A few could be...

426 HEMI Front Motor Plate, 1/16

A photo etched front motor plate for a Revell HEMI engine. Includes 4 chassis tabs for bolting on to the motor plate. Sized to fit an approximate chassis width of 1.16" (center to center). Will replace existing Revell kit mounts. For the best fit,...

Thermostat Housing 1/16

Here is a detail item you won't find everywhere - a thermostat housing for any engine. A .157" rubber line (equal to a 1:1 size of 2-1/2" radiator hose) will fit over the outlet neck found here.   Contains one thermostat / water neck...

Liberty Transmission Shifter Kit 1/16

This is a standalone shifter kit for a Liberty transmission.                 Photo of real shifter.              I'll include a print of this exploded view to help with the...