Engine Related

SBC Gasket Set, 1/24-1/25

Great for a show winning engine or a diarama scene. All the gaskets you'd find on a real engine:HeadIntakeExhaustValve CoversTiming CoverCarburetor (2 styles)Fuel Pump GasketFuel Pump Blank Plate (when using an electric fuel pump)Water Pumpand...

BBC Offset Motor Plate 1/25

A more accurate motor plate than found in a kit. It is offset for those cars with an off-center driveline.While this motor plate is copied after the one used in the Revell Pro-Sportsman kits, it can be used in any build with possible modification.It is...

Blower Restraint Plate, 1/25

This restraint plate sits under the blower and restraint straps would fasten to the slots and go over the blower to hold it down in the event it would blow up. It is universal to all blowers. This photo etched piece is etched out of .006" nickel-silver...

Big Block Ford, Crank Trigger 1/25

For that big block Ford engine to keep perfect ignition timing. Includes crank trigger wheel, sensor mount and adjustable sensor mounting bracket. A crank triggered ignition system can make more horsepower than a distributor triggered system. A crank...

Clutch Can HEMI 1/25

 Here is an item every race car needs and is required in almost all NHRA classes. This clutch will contain a clutch/flywheel explosion. This is a replica of a real world Trick Titanium clutch can and matches the bellhousing pattern on HEMI blocks...

Round 4" Aluminum (Nostalgia Style) Air Cleaner 1/25

This machined aluminum air cleaner measures 4"w x 2"h. It would be typically be found on a single carburetor.Includes photoetched wing nut and simulated filter element. The photo shows a 14" air cleaner with an added fine mesh screen...

Small Multi-Use Springs, Throttle/Hood/Brake (pair)

Two small springs for throttle linkage or to hold those semi tractor air hoses.Depending on your scale, these could be used for brake pad springs or hood-hinge springs.Spring length is .25"Contains two (2) steel springs, compression type, by Model Car...

Injector Stacks - Long 1/24-1/25

Smaller, polished aluminum injector stacks for a Hilborn style induction system. Pack contains 8 stacks, polished aluminum with a flared top. . The stacks are hollow with a 'pin' at the bottom for easy mounting Dimensions per back of...

Holley Dominator Carb & PE Details, Pair 1/25

Holley Dominator Ultra Detail Carb Kit with Photo Etch Air Horn and Linkage.  These carbs were drawn in CAD and capture as many features as possible of Holley's decades-famous Dominator race carb. The carb bodies are 3D-printed and are...

Small Block Ford Engine Crank Trigger 1/25

Here is a Crank Trigger kit, for a small block Ford engine. Includes crank trigger wheel, sensor mount and adjustable sensor mounting bracket. A crank triggered ignition system can make more horsepower than a distributor triggered system. A crank...

Radiator Shroud Set 1/25

Here is a combination of a resin radiator, shroud and and fan-surround.    Radiator dimensions: Width at the base is 1.06" Depth (front to rear) is .420" The ID at the rear most part of the fan enclosure is .615".   3 resin pieces,...

8" Diameter Dual Air Cleaners, 1/25

A pair of small air cleaners that will fit a 4bbl carb. It consists of an aluminum top and bottom with screen material.  The top is peaked in the center   Two complete air cleaners, by Detail Master, 1/25 scale.