Engine Related

Blower Accessory Set 1/25

This photo etched set includes: Blower hold-down plate Blower restraint strap buckles

4-Pulley Set #3 Smooth 1/25

A set of four polished aluminum V-groove pulleys with belt material. The face of the this pulley set is smooth and slightly cone shaped where the center is pointed outward, except for the crank...

Lenco Transmission 3-Speed/Reverse, Manual Shift 1/25

This is a complete Lenco transmission configured for 3-speeds with reverse. It is a one-piece unit including 3D-printed shifter levers (the 2 levers are really small and easy to loose).

Engine Linkage Detailing Set 1/25

This photo etched set has many different types of linkage hardware pieces for any engine. See the photo above for items in this photo etched sheet. By

Engine Detail Set, 1/25

There's a little bit of everything in this PE engine detail set. INCLUDES Battery terminals

Pulley Set #6 Polished 1/25

A set of four polished aluminum V-groove pulleys with belt material. The face of the this pulley set is smooth and slightly cone shaped where the center is pointed outward, except for the crank...

Pre-Wired 6-cyl Distributor, Black Cap, 1/25

An authentic looking 6-cylinder distributor with straight black boots at the cap and at the spark plug end. Includes a nicely detailed cap, base and aluminum stem.

Spark Plug Boots-Straight, Red-Gray, 3D, 1/25

A package of 16 straight 3D-printed spark plug boots in red or gray. 8 for the spark plugs and 8 for the distributor.   

Blower Belt, 1/24-1/25

This ribbed blower belt really adds detail and realism over a molded kit belt/pulley item. It is cast out of urethane rubber and stretches enough to fit nicely over the a pulley setup. 

Soft Clear Line - Tube .039, 1mm OD, .020" ID

This is a soft, clear line that bends easily and smoothly.  It's able to bend at a sharp angle without kinking. It is a hollow tube with a .020" ID.

Radiator or Coolant Hose .065" OD

This stranded core wire, at 1/25 scale, is used as a 1-1/2" OD liquid transfer hose or a large cable.  At 1/16 scale it equals a 1" OD heater or A/C hose. This can also serve as a 1/16 scale...

MSD Pro Mag 44 with Dual Drive, 1/25

A 3D-printed MSD Pro Mag and a Drive to add a second mag. It consists of three pieces - Body, Cap and Cover. A MSD decal is included but not shown in the photos.