Engine Related

Liberty Transmission Shifter Lever Set 1/25

You need a set of these Liberty shifters for your Door Slammer or other drag car.  Adds realism and detail to your build. Contains set of levers, brackets, linkage and instructions..   Photo etched, .015" nickel-silver plate. 1/25 scale.

4-Pulley Set, 2-Grooves 1/25

A set of four spun aluminum V-groove pulleys. Consists of two double groove and two single groove pulleys. Includes belt material. The package list this pulley set for Monogram's '37 Ford (kit #2757 & #7245), but these can be used on any engine...

Spark Plug Boots-Straight, Red-Gray, 3D, 1/25

A package of 16 straight 3D-printed spark plug boots in red or gray. 8 for the spark plugs and 8 for the distributor.    Glue the spark plug wire into the boot while it's still attached to the sprue. It's easier to handle this way.   The...

General Wiring .019” Green

This is longer than most brands at 48”. It’s multi-scale, because it represents a different size, for each scale. At 1/24-1/25 scale, it could be a larger wire like big spark plug wires, battery cables and more. At 1/16 scale it would be a...

Ignition or General Wire, Yellow .0194"

This wire can be used for many heavier electrical loads. Scale Motorsport's wire is not as stiff as most other electrical wires. It is .0194" diameter which is equal in real life to just under 1/2" or 12mm at 1/25 scale. At 1/16 scale, this wire would...

Ignition or General Wire, Red .0194"

This wire can be used for many heavier electrical loads. Scale Motorsport's wire is not as stiff as most other electrical wires. It is .0194" diameter which is equal in real life to just under 1/2" or 12mm at 1/25 scale. At 1/16 scale, this wire would...

Brad Anderson HEMI & Lenco 1/24

An all new, highly detailed, complete Brad Anderson Engineering blown HEMI with Lenco transmission. Total of 26 pieces, many are pinned for proper alignment. Choose between a 2-speed, 3-speed or 4-speed Lenco. All include reverse. Choose your...

Ignition or General Wire, Dark Blue .0194"

This wire can be used for many heavier electrical loads. Scale Motorsport's wire is not as stiff as most other electrical wires. It is .0194" diameter which is equal in real life to just under 1/2" or 12mm at 1/25 scale. At 1/16 scale, this wire would...

Distributor Vacuum Can, 1/25

Here is a small, but essential part of an ignition system. This vacuum can is necessary for engine timing. It is part of the total timing, where the distributor is adjusted fore-aft to advance or retard timing. This can gets its vacuum from a tube that...

General Wiring .019” Blue

This is longer than most brands at 48”. It’s multi-scale, because it represents a different size, for each scale. The color is a little lighter than what the product photo shows. At 1/24-1/25 scale, it could be a larger wire like big spark...

Pre-Wired 6-cyl Distributor, Black Cap, 1/25

An authentic looking 6-cylinder distributor with straight black boots at the cap and at the spark plug end. Includes a nicely detailed cap, base and aluminum stem. Also includes a center coil wire which is indicated with its wire end bent over...

Aluminum 'Hard' Line .039, 1mm OD

This is a soft aluminum line that bends easily and smoothly.  It's able to bend at a sharp angle without kinking. It is bright and can be polished.Search for Hex Fittings or Ferrules for hose ends.This hard line equals the following equivalent 1:1...