Fuel Management

Holley Dominator Carb & PE Details, Pair 1/25

Holley Dominator Ultra Detail Carb Kit with Photo Etch Air Horn and Linkage.  These carbs were drawn in CAD and capture as many features as possible of Holley's decades-famous Dominator race carb. The carb bodies are 3D-printed and are...

Blower Restraint Plate, 1/25

This restraint plate sits under the blower and restraint straps would fasten to the slots and go over the blower to hold it down in the event it would blow up. It is universal to all blowers. This photo etched piece is etched out of .006" nickel-silver...

Gray Cable .010", .25mm Dia

This looks like a stainless steel line, but it's a small gauge stainless steel wire wrapped in a gray nylon jacket. This is ideal for a throttle or parachute release cable where a steel cable is housed in a jacket. The wire core is springy and doesn't...

RBS Square 4-Hole Hat with Butterflys, 1/25

This is a CAD designed replica of an RBS Square 4-Hole Injector Hat, in 1/25 scale. The intake openings are hollowed out. Small holes across the front openings are provided for a rod to connect the butterflys to your throttle linkage and barrel valve...

8" Diameter Dual Air Cleaners, 1/25

A pair of small air cleaners that will fit a 4bbl carb. It consists of an aluminum top and bottom with screen material.  The top is peaked in the center   Two complete air cleaners, by Detail Master, 1/25 scale.  

Velocity Stacks, Small, 4bbl Carb 1/24-1/25

Smaller, polished aluminum velocity stacks for a 4bbl carburetor. Pack contains 2 stacks, turned solid aluminum, so there's no seam. The stack is hollowed-out, leaving a solid bottom.  You could drill it out so that you'd be able to see the carb...

Small Multi-Use Springs, Throttle/Hood/Brake (pair)

Two small springs for throttle linkage or to hold those semi tractor air hoses.Depending on your scale, these could be used for brake pad springs or hood-hinge springs.Spring length is .25"Contains two (2) steel springs, compression type, by Model Car...

4-Pulley Set, 1-Groove, Flathead or Other 1/25

A set of four spun aluminum V-groove pulleys. This is packaged as a Flathead pulley set but can be used for most any engine requiring smaller single groove pulleys. Consists of four single groove pulleys: Crank pulley Water pump pulley Fan...

Injector Stacks, Tall 1/24, 1/25

A set of eight machined aluminum tall, flared, injector stacks. Hilborn Style Injector Stacks 5/32 x 3/32 x 1/2. Eight aluminum stacks by Parts by Parks, 1/24-1/25 scale.

Blower Starter Bracket, 1/16

Unless your blown engine has its own starter, you'll need to start it with a blower starter. This bracket holds the blower starter and will add that special touch of detail to your engine. Here is a photo of a real-world starter. The pins fit into the...

Turbo Charger Waste Gate, Pair 1/25

Making your own single or twin turbocharger setup? Here's something you need and it would be difficult to scratch build - waste gates.  Here's a pair of 3D-printed waste gates. A wastegate is a boost-controlling device that limits...

Single Barrel/Flathead Air Cleaners 1/25

Three small machined aluminum air cleaners. Although these are single barrel air cleaners, they're also made to fit atop the Flathead Oil Filter by Parts by Parks Three aluminum pieces by Parts by Parks, 1/25 scale.