Fuel Management

Throttle Linkage Set, 1/25

A throttle linkage set with pins added to the ends of the linkage components. This will provide a more stable attachment point for linkage rods, etc.

HEMI Injector Manifold 1/25

A fuel injector manifold for your HEMI engine.   Here's a fuel plumbing diagram for this manifold.The l

Soft Line - Hose .008", .20mm OD

This is a small black twisted multi-fiber line. It is very flexible and can be bent at sharp anglesThe OD dimension is .008" or .20mm. 

Small Multi-Use Springs, Throttle/Hood/Brake (pair)

Two small springs for throttle linkage or to hold those semi tractor air hoses.Depending on your scale, these could be used for brake pad springs or hood-hinge springs.Spring length is .25"Contains...

PSI Blower 1/25

A PSI Blower in one-piece resin.For a 'roots' type blower, see the Kalbelco series of 671, 1471 and 1671 super chargers. This

Carbon Fiber Style Hat, Long 1/24

A round 3-hole hat that is typically seen in carbon fiber. This is a long version.  A shorter version is also available.

NoS or Fire Aluminum 2-Bottle Set with Upright Holder 1/25

You won't find a more realistic upright nitrous oxide bottle set than this one.  Use one as a fire bottle if you have a plumbed fire suppression system. These 10 lb bottles are made for an upright...

Blower Restraint Plate, 1/25

This restraint plate sits under the blower and restraint straps would fasten to the slots and go over the blower to hold it down in the event it would blow up. It is universal to all blowers.

Holley Dominator Carb & PE Details, Pair 1/25

Holley Dominator Ultra Detail Carb Kit with Photo Etch Air Horn and Linkage.  These carbs were drawn in CAD and capture as many features as possible of Holley's decades-famous Dominator race carb.

Injector Stacks - Long 1/24-1/25

Smaller, polished aluminum injector stacks for a Hilborn style induction system. Pack contains 8 stacks, polished aluminum with a flared top. .

RBS Square 4-Hole Hat with Butterflies, 1/25

This is a CAD designed replica of an RBS Square 4-Hole Injector Hat, in 1/25 scale. The intake openings are hollowed out. Small holes acro

Blower Starter Bracket, 1/16

Unless your blown engine has its own starter, you'll need to start it with a blower starter. This bracket holds the blower starter and will add that special touch of detail to your engine.