Shop by Manufacturer

Pro Mod / FC Slicks 1/16

If you're looking for the biggest meat to stick under those wheel tubbs, you just found it.  These are the largest 1/16 slicks on the market. There are no raised letters on these slicks.  If you want Good Year, Hoosier or M/T names on the...

Barry Grant DEMON 4bbl Carburetor 1/25

Detailed Barry Grant 4-bbl Carburetor.With single or dual carbs, you'll need a Fuel Junction Block (see ENGINE DETAILING).Photo shows a real Demon carb for reference only. Also see the Braided Lines, Hard Lines, Soft Lines and Fittings along with the...

Filler / Gas Cap (Hinged Style) 1/25

Here's a pair of gas, oil or other filler caps for your cars. This is the type that has a hinge on one side. Diameter = .17", 11/64" Cast in one piece. Contains 2 metal cast pieces, by Pro Tech 1/25 scale.

Blown Engine Fuel Injection Block 1/16

Fuel Injection Block for supercharged engines. This is the fuel block that is located behind the injector hat and behind the blower which feeds the manifold. Use Pro Tech?s .035 Braided Line along with the corresponding fittings for the fuel feed line to...

Spark Plug Boots Black 1/16

Rubber boots ready to use as is, for straight boots, or cut them and glue at a 90 degree angle for angled boots.Use in combination with your choice of color Pro Tech Spark Plug Wire.Each pack contains 8 black boots, by Pro Tech.

671 GMC Blower 1/16

A 671 blower for early dragsters or for a street machine.Blower pulley is attached to the front plate.The detail is quite good and the bolts are sharp. Check out this photo for an idea of which blower you need. Contains 2 resin pieces.

Throttle Return Spring, 1/16

A small spring to simulate a throttle return spring. This is a pretty tight spring which would have the throttle in a closed position. Made of stainless steel and measures .07" OD x .25" long. Contains a loop on one end and can be cut to length...

Pro Mag 44, Ignition & Electrical Diagrams

Nothing brings a drag racing model engine to its realism potential more than wiring. You will glance over an empty engine, but you will do a double-take when it is detailed with wiring and plumbed with fuel and injection lines. Here is a FREE...

Holley Dominator Carburetor (Pair) 1/25

A pair of nicely detailed Holly Dominator 4-bbl Carburetors. With single or dual carbs, you'll need a Fuel Junction Block (see ENGINE DETAILING). Also see the Braided Lines, Hard Lines, Soft Lines and Fittings along with the SMALL or LARGE 'T' fitting...

Steering Wheel 1/25

Sport Steering Wheel kit. The wheel grip is mastered in 3D and will be sold as either 3D printed or resin, depending on availability. Three-spoke wheel center is photo etched and replicates Grant Performance #673.   Photo of real Grant 673 steering...

Cragar 15" SuperTrick Wheels 4-Set, Hub 1/24

A highly detailed set of front and rear Cragar Super Trick wheelsThese Cragar's replicate 15" wheels used on 1970s-80s era drag cars.  Crowned centers are present on both front and rear wheels, with double-drilled pattern on rear wheels. Inner and...

Throttle Linkage Set, 1/25

A throttle linkage set with pins added to the ends of the linkage components. This will provide a more stable attachment point for linkage rods, etc. Depending on your attachment, the pin may have to be bent 90 degrees.   Photo etched...